Signature analysis Eyepoint P10

Increases
Efficiency
Improves
Support
Increases
Profitability

Signature Analysis System EyePoint P10

EyePoint P10 Signature Analysis System is a new look at the search for faulty electronic components on printed circuit boards. A desktop, inexpensive and easy-to-use system, and most importantly, does not require any technical documentation for printed circuit boards! All you need to find a malfunction on the board is the reference board and EyePoint P10. Troubleshooting is done inminutes, with guaranteed quality.

How it works?

Reference board
Study mode
Save the signature of the reference board into a file
Tested board
Troubleshooting mode
Сomprehensive report and pinpoint defective electronic components.

How it works?

Reference board
Study mode
Tested board
Troubleshooting mode
Save the signature of the reference board into a file
Сomprehensive report and pinpoint defective electronic components.

Place the reference board into EyePoint P10, place the probe on the PCB's ground and press "Start". EyePoint P10 will do following actions automatically:

  1. Take a composite high-resolution photo
  2. Detect electronic components on PCB
  3. Determine the pinout
  4. Obtain the signature (unique volt-ampere characteristics) of each output of each electronic component with flying probe
  5. Save the signature of the reference board into a file

Next place the board under test into EyePoint P10. It may be a faulty sample from the same series as the reference PCB, or the board returned by your customer as defective or even the same board after few years of operation. Switch EyePoint P10 to the troubleshooting mode and hit "Start". After 5-30 minutes, depending on the size of the board, EyePoint P10 will give you an comprehensive report and pinpoint defective electronic components. All that remains is to replace the defective chips and to check repaired PCB on EyePoint P10 again. It is that simple.